INDICATOR LIGHT MAINTENANCE. - TM-9-6115-661-13-P0128

TM 9-6115-661-13&P

Install conductor bus (13) between terminals 2 and 5.

Install tagged wires, screws (16) and washers (14) and lock washers (15) to terminals.

10. Position control panel assembly (10) with gasket (17) on switch box cover (6) and align mounting

holes.

11. Install 8 new lock washers (3) flat washers (2) and screws (4).

12. Close switch box cover (1) and secure with clamping catch (5).

4-16 INDICATOR LIGHT MAINTENANCE.

This task covers: a. Removal

c. Installation

b. Test

INITIAL SETUP

Tools

Equipment Conditions

Tool Kit, General Mechanic's

Reference

Both generator sets shut down,

Solder gun (item 2, appendix B)

Trailer support devices are

lowered, paragraph 2-3.2.1.

Materials/Parts

Solder (item 4, appendix E)

Housing, Indicator Light

Washer, Lock

REMOVAL

Release clamping catch (8, figure 4-14) and open control panel access cover.

Remove 8 screws (11), flat washers (9), lock washers (10) and control panel assembly (12). Discard

lock washers.

NOTE

The switch box assembly has eight lamps. Replacement procedures are the

same for each indicator lamp.

Tag leads connected to each terminal (13) of indicator lamp housing to be replaced, and unsolder

each lead.

Remove and retain lens (1), O-ring (14) and lamp (2).

Remove mounting nut (6) and internal tooth lock washer (5).

Slide indicator housing (3) out of control panel assembly (12) and remove O-ring (4).