CONTACTOR MAINTENANCE. - TM-9-6115-661-13-P0186

TM 9-6115-661-13&P

INSTALLATION

1. Position bus bar (1, figure 5-14) in place.

2. Install flatwashers (8), newlock washers (7) and nut (6).

3. Install lock washers (2) and nut (3).

4. Install leads (5), flat washers (9), lock washers (10) and cap screws (4).

5. Connect P3 (7) to J4 (8, figure 5-13) and position the switch box cover (4) over the switch box

assembly.

6. Install flat washers (3), lock washers (2), and screws (1) that secure the switch box cover (4).

5-12 CONTACTOR MAINTENANCE.

b. Installation

This task covers: a. Removal

INITIAL SETUP

Tools

Equipment Conditions

General Mechanic's Tool Kit

Reference

Both generator sets shut down,

Materials/Parts

para 2-5.3.1.

Washer, Lock

REMOVAL

1. Remove 21 screws (1, figure 5-15), lock washers (2), flat washers (3) that secure the switch box cover

(4) to the switch box assembly. Discard lock washers.

CAUTION

The control panel connector P3 is connected to connector J4. Movement

of the switch box cover is limited. To prevent damage to control panel

wiring harness, use caution removing switch box cover. Failure to

observe this caution can result in equipment damage.

2. Carefully position switch box cover (4) in front of the switch box assembly.

3. Disconnect P3 (5) from J4 (6) and set switch box cover (4) out of the way.

4. Remove and retain the switch box cover (4).

5. Remove four screws (7, figure 5-15) and one terminal shield (8) from the contactor (9).