BUS BAR MAINTENANCE. - TM-9-6115-661-13-P0184

TM 9-6115-661-13&P

2. Connect lead asindicated onwiring diagram (FO-1).

3. Connect P3 (7) to J4 (8) and position the switch box cover (4) over the switch box assembly.

4. Install new lock washers (2), flat washers (3) and screws (1) that secure switch box cover (4).

5-11 BUS BAR MAINTENANCE.

This task covers: a. Inspection

c. Repair

b. Removal

d. Installation

INITIAL SETUP

Tools

Equipment Conditions

General Mechanic's Tool Kit

Reference

Helicoil Insertion Tool (item 7, appendix B)

Both generator sets shut down,

para 2-5.3.1.

Materials/Parts

Washers, Lock

Insert, Screw Threaded

INSPECTION

Visually inspect for corrosion, damage, or for loose or missing hardware.

REMOVAL

1. Remove 21 machine screws (1, figure 5-13), flat washers (3), and lock washers (2) that secure the

switch box cover (4) to the switch box assembly.

CAUTION

The control panel connector P3 is connected to connector J4. Movement

of the switch box cover is limited. To prevent damage to control panel

wiring harness, use caution removing switch box cover. Failure to

observe this caution can result in equipment damage.

2. Carefully position switch box cover (4) in front of switch box.

3. Disconnect P3 (7) from J4 (8) and set switch box cover (4) out of the way.

4. Remove switch box cover (4).