ELECTRICAL LEADS MAINTENANCE. - TM-9-6115-661-13-P0183

TM 9-6115-661-13&P

5-10 ELECTRICAL LEADS MAINTENANCE.

c. Repair

This task covers: a. Removal

d. Installation

b. Inspection

INITIAL SETUP

Equipment Conditions

Tools

Reference

General Mechanic's Tool Kit

Both generator sets shut down,

para 2-5.3.1.

Materials/Parts

Washers, Lock

REMOVAL

1. Remove 21 machine screws (1, figure 5-13), flat washers (3), and lock washers (2) that secure the

switch box cover (4) to the switch box assembly.

CAUTION

The control panel comector P3 is connected to connector J4. Movement

of the switch box cover is limited. To prevent damage to control panel

wiring harness, use caution removing switch box cover. Failure to

observe this caution can result in equipment damage.

2. Carefully slide switch box cover (4) off switch box and set in front of switch box assembly.

3. Disconnect P3 (7) from J4 (8) and set switch box cover (4) out of the way.

4. Refer to FO-1, then label each end of lead to be replaced.

5. Disconnect and remove lead.

INSPECTION

Visually inspect lead for loose, broken, or corroded connections.

REPAIR

Refer to appendix G and repair or manufacture lead.

INSTALLATION

1. Position new lead in place.