 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-6115-661-13&P
CAUTION
The control panel connector P3 is connected to connector J4. Movement
of the switch box cover is limited. To prevent damage to control panel
wiring harness, use caution removing switch box cover. Failure to
observe this caution can result in equipment damage.
2.
Carefully position switch box cover (4) in front of switch box assembly.
3.
Disconnect P3 (7) from J4 (8) and set switch box cover (4) out of the way.
4.
Refer to figure FO-1, then label all leads and plugs at each end of the wiring harness to be replaced.
Disconnect all leads and plugs.
5.
6.
Remove wiring harness.
INSPECTION
Visually inspect wiring harness for damaged or frayed wires, and loose, broken, or corroded connections.
REPAIR
Refer to appendix G and repair or manufacture wiring harness.
INSTALLATION
1. Position the new wiring harness in place.
2. Connect the leads and plugs as indicated on the wiring diagram (FO-1).
3. Connect P3 (7) to J4 (8) and position the switch box cover (4) over the switch box assembly.
4. Install new lock washers (2), flat washer (3), on each machine screw (1) and secure switch box
cover (4).
5-25
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version