 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-6115-661-13&P
2. Assemble trailer leveling-support jack.
a. If removed in disassembly, install lubrication fitting (3).
b. Clamp upper leg (1) in a vise with spring pin hole facing up.
c. Insert leg base (4), align hole and install a new spring pin (2).
INSTALLATION
WARNING
Before removing trailer leveling-support jack, support rear of trailer with jack
stands. Failure to observe this warning can cause severe injury and/or death.
1.
Install bracket (6, figure 4-26) on trailer chassis (1), with flat washer (14) and screw (13), through
mounting hole in bracket (6) on trailer chassis.
2. Install flat washer (2) and a new self-locking nut (3) on screw (13).
3. Install screws (10), flat washers (9 and 5), and new self-locking nuts (4).
4.
Position leg base (11) in bracket (6) and install retaining pin (8).
Position leg base (11) and install pivot shaft (15).
5.
Install new cotter pin (16 or 7) in pivot shaft (15).
6.
Lube leveling-support jack.
7.
This task covers: a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions
Tools
Tool Kit, General Mechanic's
Reference
(item 1, appendix B)
Trailer handbrakes set, front support
Materials/Parts
leg/landing leg lowered, and rear leveling-
support jack lowered; paragraph 2-3.2.1.
Nut, Self-locking
REMOVAL
1. Remove fire extinguisher from bracket.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version