SWITCH BOX LOAD TERMINAL MAINTENANCE. - TM-9-6115-663-13-P0125

TM 9-6115-663-13&P

7. Install eight lock washers (10), flat washers (9), and screws (11) that secure control panel

assembly (12).

8. Install lens (1), O-ring (14), and lamp (2).

9. Close the control panel access cover (7) and secure with clamping catch (8).

4-17 SWITCH BOX LOAD TERMINAL MAINTENANCE.

c. Installation

This task covers: a. Removal

b. Repair

INITIAL SETUP

Equipment Conditions

Tools

Reference

Tool Kit, General Mechanic's

Both generator sets shut down,

paragraph 2-5.3.1.

Trailer support devices are

Materials/Parts

lowered, paragraph 2-3.2.1.

Terminal, Load

Wire, Round Steel, 0.072 inch diameter

QQ-W-423 Composition 302

REMOVAL

1. Remove 21 screws (2, figure 4-14), lock washers (3), and flat washers (4).

2. Release clamping catch (5) and open load terminal door (1).

CAUTION

The control panel connector P3 is connected to connector J4. Movement of

the switch box cover is limited. To prevent damage to control panel wiring

harness, use caution removing switch box cover. Failure to observe this

caution can result in equipment damage.

3. Carefully position switch box cover (15) in front of switch box assembly.

4. Disconnect P3 (6) from J4 (7).

5. Remove switch box cover (15).

6. Disconnect external load terminal lead from the defective terminal (14).

NOTE

For removal of ground load terminal go to step 8.