|
|
TM 9-6115-661-13&P
c. Installation
This task covers: a. Removal
b. Repair
INITIAL SETUP
Equipment Conditions
Tools
Tool Kit, General Mechanic's
Reference
(item 1, appendix B)
Trailer handbrakes set and front support leg/landing
Jack Stand (item 2, appendix B)
leg lowered; paragraph 2-3.2.1.
Both generator sets shut down; paragraph 2-5.3.3
Materials/Parts
Pin, Cotter
Pin, Spring
Fitting, Lubrication (if needed)
Grease, GAA (item 2, Appendix E)
Rivets (item 11, appendix 1)
REMOVAL
WARNING
Before removing trailer leveling-support jack, support rear of trailer with jack stands.
Failure to observe this warning can cause severe personal injury or death.
L Support rear of trailer with jack stands.
2. Turn leg base (1, figure 5-21) to take weight off leg prop.
3. Remove either one of two cotter pins (2 or 3) from pivot shaft (4) and discard cotter pin.
4. Hold leg base (1) steady and remove pivot shaft (4) with remaining cotter pin in place.
5. Lift leg base (1) slightly to take weight off retaining pin (5) and remove retaining pin. Move leg base
(1) and attached parta out of bracket (7).
6. Remove three rivets (6) and bracket (7) from trailer chassis (8).
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |