Table 2. STE/ICE-R NO-GO-Chain Tests - continued

TM 9-2320-386-24-1-1

0017 00

Table 2. STE/ICE-R NO-GO-Chain Tests (Contd)

NOTE

Test G01, VTM Connections and Checkout, must be

performed before running any other STE/ICE-R test.

DCA

ENGINE CRANK NO START

NG30

MODE

CHECK CRANKING SPEED:

Dial 10 into TEST SELECT and press TEST.

Crank engine with fuel shutoff switch engaged and watch

readout display.

TEST NO.

TEST

Compare result with minimum cranking speed of 100 RPM.

ENGINE RPM

(AVERAGE)

Is cranking speed OK?

YES

Proceed to Starter Circuit Tests,

NG80.

CAUTION

Before opening fuel line, ensure area

around fuel line is clean.

NG80

CHECK FUEL SUPPLY:

Verify that there is fuel in the tank.

If fuel filter has been changed or fuel tank has been run

dry, bleed air out of fuel system as necessary

(TM 9-2320-386-10).

Drain any water from fuel/water separator. Continue to

drain until fuel appears.

Check for kinked, flattened, or broken fuel lines from tank

to filter and engine. If equipped with quick disconnect

fittings, check for blockage in fittings.

Check fuel shutoff solenoid and circuitry. Refer to Electrical

Troubleshooting (WP 0011 00).

Check vent for ice in lines during freezing weather.

Proceed to step 3.