WIRING HARNESS MAINTENANCE.

TM 9-6115-663-13&P

5-9 WIRING HARNESS MAINTENANCE.

c. Installation

Removal

This task covers:

d. Inspection

Repair

INITIAL SETUP

Equipment Conditions

Tools

Reference

Tool Kit, General Mechanic's

Both generator sets shut down, para 2-5.3.1.

Crimp Took (item 4)

Materials/Parts

Washers, Lock

REMOVAL

1. Remove 21 machine screws (1, figure 5-13), lock washers (2), and flat washers (3) that secure the

switch box cover (4) to the switch box assembly. Discard lock washers.

The control panel connector P3 is connected to connector J4. Movement of the switch box

cover is limited. To prevent damage to control panel wiring harness, use caution

removing switch box cover. Failure to observe this caution can result in equipment

damage.

2. Carefully position switch box cover (4) in front of switch box assembly.

3. Disconnect P3 (7) from J4 (8) and set switch box cover (4) out of the way.

4. Refer to figure FO-1, then label all leads and plugs at each end of the wiring harness to be replaced.

5. Disconnect all leads and plugs.

6. Remove wiring harness.

INSPECTION

Visually inspect wiring harness for damaged or frayed wires, and loose, broken, or corroded connections.

Refer to appendix G and repair or manufacture wiring harness.