Section III. MAINTENANCE PROCEDURES - TM-9-6115-663-13-P0155

TM 9-6115-663-13&P

Section lll. MAINTENANCE PROCEDURES

5-5 GENERAL.

Refer to TM 9-6115-645-24 for generator set maintenance, and to TM 9-2815-256-24 for engine

maintenance. Refer to TM 9-2330-205-14&P for trailer maintenance. Direct Support level maintenance

procedures are provided in paragraphs 5-6 through 5-14.

5-6 REPLACE GENERATOR SET.

b. Installation

This task covers: a. Removal

INITIAL SETUP

Tools

Equipment Conditions

Reference

Tool Kit, General Mechanic's

Both generator sets shut down, para 2-5.3.1.

Lifting device with 6000 lb capacity

Personnel Required

Materials/Parts

Nuts, Self-locking

Rope

REMOVAL

1. When removing the generator set from unit A of the power plant, disconnect P1 (3, Figure 5-10)

from generator set.

2. Loosen GND terminal of generator set and disconnect ground cable (5) from the generator set.

3. Remove the four screws (1), eight flat washers (7), and four self-locking nuts (6) securing the generator

set to the trailer.

4. Insert ropes (10) through each of four lifting rings (8) on the generator set as shown in figure 5-10.

5. With one person at each rope (10) to steady and guide generator set (9), life generator set.

INSTALLATION

WARNING

When lifting the generator set, use lifting equipment with a minimum lifting capacity of

6000 lb. Do not stand under the generator set while it is being lifted. Do not permit

generator set to swing. Failure to observe this warning can result in severe personal

injury or death.