|
|
TM 9-6115-663-13&P
REPAIR
When the rope (9) requires replacement, perform the following
a. Cut old rope (9) from box wrench (4).
b. On new rope, flare each end to prevent unraveling.
c. Install new terminal lug (7) to one end of rope (9).
d. Thread other end of rope (9) through the opening in handle of load terminal wrench (4).
e. Install conductor splice (5) to secure rope (9) to the wrench (4).
INSTALLATION
1. Place the loop clamp (6) so that mounting holes are in alignment with switch box cover holes.
2. Drop terminal lug end of rope (9) with box wrench (4) through loop clamp (6) as shown in figure 4
10.
3. Install screw (8), two flat washers (3), one terminal lug (7), new lock washer (2), and nut (1) that
secures loop clamp (6) to switch box cover.
4. Refer to paragraph 412 and perform steps 13 through 16 of Inspection.
b. Installation
This task covers: a. Removal
INITIAL SETUP
Materials/Parts
Tools
Tool Kit, General Mechanic's
Rivets, Blind Head
(item 1, appendix B)
Equipment Conditions
Drill, 1/4-inch
(item 2, appendix B)
Reference
Riveter, Blind Head
Both generator sets shut down,
(item 5, appendix B)
paragraph 2-5.3.1.
Trailer support devices are
lowered, paragraph 2-3.2.1.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |