 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R NO-GO-Chain Tests - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0017 00
Table 2. STE/ICE-R NO-GO-Chain Tests (Contd)
NOTE
Test G01, VTM Connections and Checkout, must be
performed before running any other STE/ICE-R test.
DCA
BATTERY TESTS
NG81
MODE
MEASURE BATTERY RESISTANCE CHANGE:
1
Dial 75 into TEST SELECT. Press and release TEST.
Does GO appear?
PROMPTING
MESSAGE
TEST NO.
TEST
75
BATTERY
YES
NO
RESISTANCE CHANGE
(CURRENT PROBE)
Hold open fuel shutoff switch.
Error message is displayed.
Engage starter switch until
OFF appears on the display.
Refer to TM 9-4910-571-12&P,
PROMPTING
correct as necessary, and
Wait for display to change.
MESSAGE
repeat step 1.
Is a test value displayed?
1
NO
YES
If display shows GO, there is a bad connection
Value of 50 milliohms/sec is displayed.
in the starter circuit. Check cables and con-
nections to starter and retest. If display still
shows GO, then you may have a very poor
Is resistance change less than above limit?
battery. Charge battery and retest.
If display shows .9.9.9.9 there may be a bad
connection on a battery. Clean and tighten
YES
NO
battery connections and retest.
If display shows , or .9.9.9.9, a battery
may be in a discharged state. Check battery
Proceed to step 2.
Proceed to step 3.
electrolyte level, charge battery, and then
retest (TM 9-6140-200-14).
2
3
If display shows E013 three consecutive times,
or , or .9.9.9.9 after a battery has been
charged, replace battery (WP 0122 00).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version