 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R NO-GO-Chain Tests - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0017 00
Table 2. STE/ICE-R NO-GO-Chain Tests (Contd)
DCA
STARTER CIRCUIT TESTS (Contd)
NG80
MODE
CHECK STARTER VOLTAGE:
TEST NO.
TEST
3
Dial 68 into TEST SELECT and press TEST.
68
STARTER MOTOR
VOLTAGE
Engage fuel shutoff switch and crank the engine and
observe the displayed voltage.
Is the voltage above 18.5 volts minimum?
YES
NO
Proceed to step 5.
5
STARTER NEGATIVE CABLE DROP:
TEST NO.
TEST
4
Dial 69 into TEST SELECT and press TEST.
69
STARTER NEGATIVE
CABLE DROP
Engage fuel shutoff switch and crank the engine and
observe the displayed voltage.
Is the cable drop less than the limit on the VTC?
YES
NO
Inspect and clean all ground cables from starter,
engine, and batteries, and check for integrity.
Repair as necessary (WP 0125 00).
Repeat step 4.
4
Replace starter motor (WP 0091 00).
NOTE
After completing repair, rerun the GO-Chain
tests to verify that the problem is fixed and
that no other problems exist.
0017 00-14
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version