 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R NO-GO-Chain Tests - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0017 00
Table 2. STE/ICE-R NO-GO-Chain Tests (Contd)
STARTER CIRCUIT TESTS
DCA
NG80
(Contd)
MODE
YES
NO
Is GO still displayed?
NO
YES
Is starter circuit resistance
within 5-35 milliohms?
Proceed to TM 9-4910-571-12&P
for offset fault isolation.
YES
NO
Is resistance high?
Engage fuel shutoff switch
and try to crank engine
again.
Problem due to either
If GO is still displayed
NO
YES
weak batteries or tight
after crank attempt,
engine.
starter is not being
energized.
Resistance is low.
Proceed to Battery Tests,
Proceed to step 3.
NG81.
Look for short in starter
circuit.
If none found, replace starter
3
motor (WP 0091 00).
NG81
Inspect and clean starter and battery
cables.
NOTE
Check batteries per NG81 test.
After completing repair, rerun the GO-Chain
tests to verify that the problem is fixed and
Repeat step 1.
that no other problems exist.
If resistance is still high, replace starter
motor (WP 0091 00).
0017 00-13
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version