 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R NO-GO-Chain Tests |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0017 00
Table 2. STE/ICE-R NO-GO-Chain Tests
TK
LOW OIL PRESSURE CHECK
NG05
MODE
INSTALL TRANSDUCER - DO OFFSET:
1
Stop vehicle engine.
Remove oil pressure transducer (WP 0100 00).
TEST NO.
TEST
Install pressure transducer TK item 17 (blue
stripe) in place of oil pressure transducer on
01
engine.
50
0-1000 PSIG
Connect P1 of the transducer cable W4 to J1 or J2
PRESSURE
on the VTM.
Connect P2 of the transducer cable to the connector
on the pressure transducer.
Dial 50 into TEST SELECT.
PROMPTING
Press and hold TEST until CAL message
MESSAGE
appears on display.
Release TEST.
Wait for offset value to appear on the display.
Is the offset value within the limits -150 to +150?
Proceed to TM 9-4910-571-12&P
YES
NO
for offset fault isolation.
CHECK OIL PRESSURE
2
Dial 01 into TEST SELECT and press TEST.
PROMPTING
MESSAGE
When PASS appears, dial 50 into TEST SELECT
and press TEST. VTM will now display RPM and
NOTE
oil pressure alternately.
After completing repair, return the
Start engine.
GO-Chain test to verify that the
problem is fixed and that no other
Check the VTM display for correct oil pressure.
problems exist.
Is the oil pressure above 15 PSI (103 kPa) ?
Stop the engine immediately.
Refer to PMCS (WP 0022 00) to
NO
check oil type and replace oil
filters.
If the reading is still bad, refer
to Mechanical Troubleshooting
Proceed to Gauge Test, NG31.
YES
NG31
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version