|
|
TM 9-2320-361-24-1
0006 00
MECHANICAL SYSTEMS TROUBLESHOOTING - UNIT (Contd)
Table 21. Personnel Fuel Burning Heating Troubleshooting Procedures (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2. HEATER WILL NOT
WARNING
OPERATE
Diesel fuel is flammable. Do not
perform troubleshooting checks
near open flame, sparks, or
electricity. Injury or death to
personnel may result.
Compressed air source must not
exceed 30 psi (207 kPa). Wear
eyeshields when cleaning with
compressed air. Failure to wear
eyeshields may result in injury to
personnel.
1. Refer to Heating System
Troubleshooting Procedures in
WP 0015 00, malfunction 3.
2. Make sure fuel shutoff valve is in If fuel shutoff valve is damaged (or
stuck in OFF or partial ON
full ON position.
position), replace fuel shutoff valve
(WP 0377 00).
If water or contamination is
3. Check heater fuel filter for
present, clean and flush entire fuel
contamination (WP 0354 00).
system. Dry with compressed air.
4. Check fuel lines for breaks,
If broken, kinked, or leaky joints
bends, kinks, or leaking joints.
are found in fuel lines, replace
(WP 0376 00 and WP 0383 00).
5. Check fuel pump discharge.
1. Remove fuel line from fuel pump
output (WP 0353 00).
2. Use a clean container for fuel
discharge recovery.
3. Position heater control box to
RUN position.
4. If fuel pump fails to pump an
adequate amount of fuel, 1/2 pint
(0.24 liter) in 30 seconds, replace
(WP 0353 00).
6. Inspect exhaust system for
If exhaust pipe is restricted or
restrictions.
damaged, repair or replace
(WP 0355 00).
7. Check for proper operation of
1. If vent or control cables are
defroster and heat diverter
broken, replace (WP 0248 00 and
control cables
WP 0249 00).
(TM 9-2320-361-10).
2. If fuel burning heater still fails to
operate, replace fuel burning
heater (WP 0351 00).
END OF WORK PACKAGE
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |