 |
|||
|
|
|||
|
Page Title:
FUEL BURNING PERSONNEL HEATER REMOVAL, REPAIR, TEST, AND REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME
10
NOTE
Fuel flow test and adjustment should be done even on
new fuel control valve. Fuel control valve must be set
for use with different fuels. A stopwatch or watch
with a second hand is needed for this test.
1.
Hold fuel outlet (1) of fuel control valve (2) over overflow container (3).
2.
Make sure HI-LO switch (4) is in LO position. Flip control switch (5) to
RUN position. Fuel pump should be pumping.
3.
Flip HI-LO switch (4) to HI.
Let fuel flow into overflow container (3) for
a few seconds.
4.
Let fuel flow into graduate (6) for exactly one minute. Flip HI-LO switch
(4) to LO position. Flip control switch (5) to OFF position.
Place graduate (6) on a level surface. Read level of fuel (7) as shown.
5.
Level of fuel should be within limits given in table for type of fuel used.
Diesel Fuel
Fuel Type
Combat
DF1
DF2
DFA
Gasoline
14 to 18
14 to 18
Flow Rate
15 to 19
15 to 19
(cc/min)
IF FUEL FLOW IS WITHIN GIVEN LIMITS, GO TO FRAME 11.
IF FUEL FLOW IS NOT WITHIN GIVEN LIMITS, GET NEW FUEL CONTROL VALVE.
END OF TASK
21-88
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version