 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 2
1.
If new worm brake stud (1) is put on worm (2), the new stud will not have
a drilled hole for retaining pin (3).
2.
Put new worm brake stud (1) on worm (2) with flat on stud, facing the outside.
3.
Put hole on worm brake stud (1) 1 1/8 inches from end of worm (2).
4.
Drill a 3/8-inch diameter hole into worm brake stud (1). Ream to 0.375 to
0.376-inch diameter.
5.
If new brakeshaft collar (4) is put on worm brake stud (1), drill new collar
on one side only.
Put new brakeshaft collar (4) on worm brake stud (1). Aline hole in collar
6.
with hole in stud.
7.
Using hole in stud and collar as a guide, drill a 3/8-inch diameter hole through
blank side of brakeshaft collar (4). Ream collar to 0.375 to 0.376-inch
diameter. Countersink both sides of collar 1/16-inch deep by 80 to 100.
Put brakeshaft collar (4) on worm brake stud (1) and put in retaining pin (3).
8.
Flare each end of retaining pin (3) on brakeshaft collar (4).
9.
10.
File or grind each end of retaining pin (3) flush with outer surface of brake-
shaft collar (4).
GO TO FRAME 3
18-114
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version