Section III. FENDERS, RUNNING BOARDS, AND WINDSHIELD ASSEMBLY

TM 9-2320-209-34-2-2

FENDERS,

RUNNING

BOARDS,

AND

WINDSHIELD

ASSEMBLY

FRONT FENDER REMOVAL, REPAIR, AND REPLACEMENT.

NOTE

This task is the same for left and right front

fenders except as noted.

TOOLS:

No special tools required

SUPPLIES:

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

Clean rags

PERSONNEL: T Wo

EQUIPMENT CONDITION:

Truck parked, engine off, handbrake set.

Preliminary Procedures.

(1) Open hood.

Refer to TM 9-2320-209-10.

(2) If working on right fender of truck with exhaust stack, remove exhaust

stack. Refer to TM 9-2320-209-20.

(3) If working on left fender of truck and truck has personnel hot water

heater, remove personnel hot water heater, Refer to TM 9-2320209-20.

(4) If working on left fender, and truck has vehicular compartment heater,

remove vehicular compartment heater and exhaust tube. Refer to TM 92320-209-20.

(5) If working on right fender, remove air cleaner intake hood. Refer to

TM 9-2320-209-20.

(6) If working on right fender and vehicle is equipped with an engine com-

partment heater, remove clamp holding heater control wire and push wire out of way.

Refer to Hot Water Personnel Heater Blower Motor Repair, TM 9-2320-209-20.

(7) If working on right fender, remove hood right side panel. If working

on left fender, remove hood left side panel. Refer to TM 9-2320-209-10.