Assembly of Rack Assembly.

9-2320-209-20-3-3

h. Assembly of Rack Assembly.

FRAME 1

NOTE

The front part of boards have recesses around the

screw holes to bury the screw head. The back parts

do not have recesses around the screw holes. Board

(1) has eight holes.

Find front part of board (1). Put eight square neck screws (2) through

eight holes in board so screw heads are on front side.

Put square neck screws (2) through end bow packet assemblies (3) and bow

pocket assemblies (4). Using 1/2-inch wrench, start nuts (5) onto square

neck screws. If screws do not come through enough to start nuts, use

mallet and hammer screws in.

Find front part of board (6), which has 10 holes. Put eight square neck

screws (7) through holes in board so screw heads are on front side.

Put square neck screws (7) through end bow pocket assemblies (3) and

bow pocket assemblies (4). Using 1/2-inch wrench, start nuts (8) onto

square neck screws. If screws do not come through enough to start nuts,

use mallet and hammer screws in.

GO TO FRAME 2