REAR SPRING SEAT WITH BEARINGS REMOVAL AND REPLACEMENT.

TM 9-2320-209-20-3-2

17-10. REAR SPRING SEAT WITH BEARINGS REMOVAL AND REPLACEMENT.

TOOLS:

1/2-inch wrench

Brass punch

1 1/16-inch wrench

Jack (2)

Torque wrench, 600 pound-

Wheel bearing remover and replacer,

feet capacity

pn 7082863

Flat-tip screwdriver

Oil seal replacer, pn C-10937827

Needle nose pliers

Jack stand (2)

SUPPLIES:

Cover gasket

Nut lock

Artillery and automotive grease, type GAA, MIL-G-10924

Rag

PERSONNEL:

One

EQUIPMENT

CONDITION:

Truck parked, engine off, handbrake set, front wheels

chocked.

Preliminary Procedures.

(1) Jack up and support rear axle housings. Refer to Part 1, para 11-3.

(2) Remove rear wheels. Refer to TM 9-2320-209-10.

(3) Put jack under cross shaft and support it.

Removal.

Using 1/2-inch wrench, unscrew and take out six screws (1) and lockwashers

(2).

2. Take off cover (3) and gasket (4). Throw away gasket.

GO TO FRAME 2