REAR SPRING SEAT REPAIR.

TM 9-2320-209-20-3-2

NOTE

This task is for removal and replacement of

bearing cups. The task is the same for re-

moval and replacement of the solid adapter

bushings.

Hammer

TOOLS:

Remover and replacer, pn 7082863

Screw, pn 7083216

SUPPLIES:

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

Rag

Artillery and automotive grease, type GAA, MIL-G-10924

Plywood, 1 x 12 x 12 inches, with 5-inch hole to clear spring seat

cups

PERSONNEL:

One

Truck parked, engine off, handbrake set.

EQUIPMENT

CONDITION:

Preliminary Procedures.

(1) Take rear spring seat off truck. Refer to para 17-8.

WARNING

Dry cleaning solvent is flammable. Do not use

near an open flame. Keep a fire extinguisher

nearby when solvent is used. Use only in well-

ventilated places. Failure to do this may result

in injury to personnel and damage to equipment.

(2) Using rag wet with solvent, clean cross shaft where spring seat was.

Check cross shaft for damage. Tell direct support about damage.