|
|
TM
9-2320-209-20-3-2
DRAG
LINK
ASSEMBLY
REPAIR.
Six-point
7/16-inch
wrench
TOOLS:
Solvent,
dry
cleaning,
type
II
(SD-20),
Fed.
Spec
P-D-680
SUPPLIES:
PERSONNEL:
One
Truck
parked,
engine
off,
handbrake
set.
EQUIPMENT
CONDITION:
NOTE
Repair
of
drag
link
assembly
is
limited
to
the
replacement
of
parts
found
damaged
during
inspection.
1.
Remove
drag
link
assembly.
Refer
to
para
All
parts
except
grease
fittings
are
off
drag
link
when
drag
link
assembly
is
taken
out.
If grease fittings (1) are bad, using wrench ,
unscrew
them
from
drag
link
2.
(2). Using wrench, screw in new fittings.
WARNING
Dry
cleaning
solvent
is flammable. Do not use near an
Keep a
fire extinguisher nearby when sol-
open
flame.
vent
is
used.
Use
only
in
well-ventilated
places.
Fail-
ure to do this may result
in
injury
to
personnel
and
damage to equipment.
3.
Using
solvent,
clean
all
parts.
Check
all
parts.
Throw
away
bad
parts
and
get
new
parts
in
their
place.
4.
Replace
drag
link
assembly.
Refer
to
END
OF
TASK
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |