FUEL PUMP (IN-TANK) REMOVAL AND REPLACEMENT - continued

TM 9-2320-209-20-3-1

FRAME 2

WARNING

Dry cleaning solvent is flammable. Do not use near

an open flame. Keep a fire extinguisher nearby when

solvent is used. Use only in well-ventilated places.

Failure to do this may result in injury to personnel

and damage to equipment.

Take off protective cover from hole in tank. Clean mating flanqes of fuel

pump and tank with dry cleaning solvent. Apply thin coat of sealer com-

pound to threads of fuel fittings before assembling.

Put new gasket (1) on fuel tank (2) and aline 10 holes.

CAUTION

Be very careful when putting fuel pump in tank so that

electrical cable shield will not scrape hole. Damage to

the shield could cause electrical failure.

Put fuel pump (3) in tank (2) as shown.

Aline holes in pump with holes

in gasket (l) and tank (2) .

Using screwdriver, screw in and tighten 10 screws (4) with 10 lockwashers

(5) through holes in pump mounting flange.

GO TO FRAME 3

TA 047132

4-49