LOWER ROOF ACCESS STEP

TM 10-5411-233-13&P

CARGO BED COVER (CBC), TYPE III, 2 1/2 T CARGO TRUCK, LMTV, AND LMTV TRAILER 0033 00

UNIT MAINTENANCE

LOWER ROOF ACCESS STEP

THIS SECTION COVERS:

Inspect, Replace

INITIAL SETUP:

Personnel Required: One

Maintenance Level - Unit

Materials/Parts

Tools and Special Tools

General Mechanic Tool Kit (WP 0041, Table 2,

Item 1)

GENERAL

This procedure contains information and instructions to keep the CBC safe and in good working order by

inspecting and replacing the lower roof access step.

INSPECT

Inspect the roof access step and ensure that there are no surfaces that are cracked or otherwise

damaged that could prevent the step from performing in a safe manner.

REPLACE

NOTE

If replacing the upper roof access step, refer to WP 0028 for

maintenance instructions.

To replace either of the lower roof access steps (1), remove the two hex head bolts (2) located on the

outside of the CBC.

While positioned in the opening of the personnel door, place a wrench on the hex locknut (3) on the inside

of the CBC while placing a second wrench on the head of the hex head bolt (2) located on the outside of

the CBC.

Loosen and remove the hex head bolt (2), flatwasher (4), and locknut (3).

Remove the defective roof access step (1).

Install a new roof access step (1) into position in the recessed mounting plate in the side wall of the CBC.

Align the holes on the roof access step with the holes on the side wall recessed mounting plate of the

CBC.

Install the two hex head bolts (2) through the step and side wall from the outside of the CBC.

0033 00-1