FIGURE AND ITEM NUMBER INDEX - TM-9-6115-661-13-P0224

TM 9-6115-661-13&P

F-43 FIGURE AND ITEM NUMBER INDEX

F-4.3.1

FIG. Column. The column lists the number of the figure where the item is identified/located

in Section II and III.

F-4.3.2

ITEM Column. The item number is that number assigned to the item as it appears in the

figure referenced in the adjacent figure number column.

F-4.3.3

STOCK NUMBER Column. This column lists the NSN for the item.

F-4.3.4

CAGEC Column. The Commercial and Government Entity Code (CAGEC) is used to identify

the manufacturer, distributor, or Government agency, etc., that supplies the item.

F-4.3.5

PART NUMBER Column. Indicates the primary number used by the manufacturer

(individual, firm, corporation, or Government activity), which controls the design and characteristics of the

item by means of its engineering drawings, specifications standards, and inspection requirements to

identify an item or range of items.

F-5

SPECIAL INFORMATION.

F-5.1 Usable on Code. The usable on code appears in the lower left corner of the DESCRIPTION AND

USABLE ON CODE (UOC) column heading. Usable on codes are shown as "UOC . . ." on the next line

below the last line of the applicable item description/nomenclature. The UOC entry begins at the left edge

of the column. Uncoded items are applicable to all models. Identification of the usable on codes used in

this publication are:

USED ON

CODE

AN/MJQ-39

EVX

PU-800

EVW

PU-801

EVV

PU-802

ESV

PU-801A

FMG

It takes two Power Units PU-800 to makeup one Power Plant AN/MJQ-39. Therefore, most parts for

Power Plant AN/MJQ-39 will have a UOC of EVW. Only parts unique to Power Plant AN/MJQ-39 will

have a UOC of EVX.

F-5.2 Fabrication Instructions. Bulk materials required to manufacture items are listed in the BULK

MATERIALS functional group of this RPSTL. Part numbers for bulk materials are also referenced in the

DESCRIPTION AND UOC column of the line item entry for the item to be manufactured/fabricated.

Detailed fabrication instructions for the items source coded to be manufactured or fabricated are contained

in Appendix G.

F-5.3 Index Numbers. Items listed under FIG.BULK in the DESCRIPTION AND UOC column will

have an index number shown in the ITEM NO. column. This index number is used as a cross-reference

between the National Stock Number/Part Number Index and the bulk materials list in Section II.

Change 3

F-7