EXPLANATION of COLUMNS (SECTION IV). - TM-9-6115-661-13-P0223

TM 9-6116-661-13&P

F-3.2.6 QTY (Column (6)). The QTY (quantity per figure column) indicates the quantity of the item

used in the breakout shown on the illustration figure, which is prepared for a functional group,

subfunctional group, or an assembly. A "V" appearing in this column in lieu of a quantity indicates that

the quantity is variable and the quantity may vary from application to application.

F-4 EXPLANATION of COLUMNS (SECTION IV).

F-4.1 NATIONAL STOCK NUMBER (NSN) INDEX.

F-4.1.1 STOCK NUMBER column. This column lists the NSN by National item identification number

(NIIN) sequence. The NIIN consists of the last

NSN

nine digits of the NSN (i.e., 5305-01-674-1467). When using this

NIIN

column to locate an item, ignore the first 4 digits of the NSN. However, the complete NSN should be used

when ordering items by stock number.

F-4.1.2 FIG. column. This column lists the number of the figure where the item is identified/located.

The figures are in numerical order in Section II and Section III.

F-4.1.3

ITEM column. The item number identifies the item

associated with the figure listed in the adjacent FIG. column. This item is also identified by the NSN

listed on the same line.

F-4.2 PART NUMBER INDEX. Part numbers in this index are listed by part number in ascending

alphanumeric sequence (i.e., vertical arrangement of letter and number combination which places the first

letter or digit of each group in order A through Z, followed by the numbers 0 through 9 and each following

letter or digit in like order).

F-4.2.1

CAGEC column. The Commercial and Government Entity Code (CAGEC) is used to identify

the manufacturer, distributor, or Government agency, etc., that supplies the item.

F-4.2.2

PART NUMBER column. Indicates the primary number used by the manufacturer

(individual, firm, corporation, or Government activity), which controls the design and characteristics of the

item by means of its engineering drawings, specifications standards, and inspection requirements to

identify an item or range of items.

F-4.23

STOCK NUMBER column. This column lists the NSN for the associated part number and

manufacturer identified in the PART NUMBER and CAGEC columns to the left.

F-4.2.4

FIG. column. This column lists the number of the figure where the item is identified/located

in Section II and III.

F-4.2.5

ITEM column. The item number is that number assigned to the item as it appears in the

figure referenced in the adjacent figure number column.

F-6