CYLINDER HEAD (IN-VEHICLE) MAINTENANCE - continued

TM 9-2320-386-24-1-2

0302 00

CYLINDER HEAD (IN-VEHICLE) MAINTENANCE (Contd)

26.

Install new O-rings (1) and (6) and fuel line (3) on adapter (8) of governor (7) and tee fitting (5), and

tighten nuts (2) and (4).

27.

Install bracket (12), with accelerator cable (10) and throttle control cable (11) attached, on

governor (7) with two washers (13) and screws (14).

28.

Install bracket (9), with accelerator cable (10) and throttle control cable (11) attached, on throttle

lever (17) with washer (16) and nut (15).

29.

Install new gasket (18) and crankcase breather base (19) on engine (29) with two washers (20),

screws (21), washers (28), and screws (27).

30.

Install breather tube (25) on engine (29) with spacer (26), clamp (22), washer (23), and screw (24).

31.

Install ground (GND) strap (33) to stud (30) on firewall (31) with new lockwasher (32) and new

locknut (34).

32.

Install new O-ring (38) and fuel line (39) on elbow (36) at rear of cylinder head (37), and tighten nut (35).

0302 00-24