 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R NO-GO-Chain Tests - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0017 00
Table 2. STE/ICE-R NO-GO-Chain Tests (Contd)
DCA
GAUGE TEST (Contd)
NG31
MODE
ISOLATE FAULT TO SENDING UNIT OR GAUGE:
3
Remove wire from engine temperature or oil
pressure sending unit on vehicle.
Connect red clip lead of W2 to wire removed from
sending unit.
Connect black clip lead to a good ground.
Press TEST.
Turn vehicle accessory switch ON.
Does VTM indicate battery voltage?
YES
NO
Refer to Electrical
Troubleshooting (WP 0011 00)
to check and isolate fault to
wiring harness or gauge.
Replace engine temperature
transducer (WP 0100 00) as
applicable.
NOTE
After completing repair, rerun the GO-Chain
tests to verify that the problem is fixed and
that no other problems exist.
0017 00-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version