 |
|||
|
|
|||
|
Page Title:
FRONT WINCH PROPELLER SHAFT REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-2
0346 00
FRONT WINCH PROPELLER SHAFT REPLACEMENT (Contd)
REMOVAL
NOTE
Place front winch control lever in low position to remove screws,
then in neutral position to gain access to remaining screws.
1.
Remove four screws (3), locknuts (1), and rear flange (11) from transmission power takeoff
flange (2). Discard locknuts (1).
2.
Remove two cotter pins (6), pin (5), propeller shaft (4), and yoke (8) from front winch shaft (7).
3.
Slide rear yoke (10) off propeller shaft (4).
INSPECTION
Inspect two universal joints (9) for looseness or roughness. If damaged, replace universal joint (9)
(WP 0141 00).
INSTALLATION
1.
Place a light coat of GAA grease on propeller shaft (4) splines and install rear yoke (10) and rear
flange (11) on propeller shaft (4).
2.
Install front yoke (8) and propeller shaft (4) on front winch shaft (7) and align pin (5) hole with
front winch shaft (7) hole. Install pin (5) through front yoke (8) and winch shaft (7) and secure
with two new cotter pins (6).
3.
Install rear yoke (10) and rear flange (11) to transmission PTO flange (2) with four screws (3) and
new locknuts (1).
4.
Lubricate front winch propeller shaft (WP 0020 00).
5.
Connect battery ground cable (WP 0126 00).
6.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
6
7
4
5
3
2
8
1
9
10
9
11
END OF WORK PACKAGE
0346 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version