 |
|||
|
|
|||
|
Page Title:
TRANSFER CASE CONTROLS AND LINKAGE MAINTENANCE (W/PTO) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0133 00
TRANSFER CASE CONTROLS AND LINKAGE MAINTENANCE (W/PTO) (Contd)
PTO LOCK ADJUSTMENT
1.
Ensure transfer case shift handle (3) is in NEUTRAL.
2.
Move PTO shift control handle (1) to disengaged position and ensure PTO control lock (2) can be
turned parallel to handle (1) to prevent rearward movement of PTO shift control handle (1).
3.
Remove locknut (4) and ball pivot end (12) from PTO shift lever (8). Discard locknut (4).
NOTE
Perform step 4 on vehicles with transfer case lockout arms.
4.
Remove cotter pin (9), clevis pin (7), and clevis (6) from PTO shift lever (8). Discard cotter pin (9).
5.
Ensure PTO shifter lever (5) is in disengaged position (rear detent).
NOTE
Assistant will help with steps 6 through 9.
6.
Place PTO control lock (2) parallel to handle (1) and hold tight to cab floor.
7.
Loosen two jamnuts (11) and adjust (10) to align ball pivot end (12) to fit freely in PTO shift
lever (5) hole. Tighten two jamnuts (11).
8.
Connect ball pivot end (12) on PTO shift lever (8) with new locknut (4).
NOTE
Perform steps 9 and 10 on vehicles with transfer case lockout
arms.
9.
Loosen jamnut (5) and adjust clevis (6) to align holes in clevis (6) with holes in PTO shift lever (8).
Tighten jamnut (5).
10.
Connect clevis (6) on PTO shift lever (8) with clevis pin (7) and new cotter pin (9).
11.
Install driver's seat (WP 0236 00).
12.
Lubricate PTO shift lever (WP 0020 00).
13.
Install cab tunnels (WP 0230 00).
14.
Connect battery ground cable (WP 0126 00).
15.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0133 00-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version