LUBRICATION INSTRUCTIONS - TM-9-2320-361-24-10353

TM 9-2320-361-24-1

0020 00

FIELD MAINTENANCE INSTRUCTIONS

2-1/2 TON, 6X6, M44A2 SERIES TRUCKS (MULTIFUEL)

LUBRICATION INSTRUCTIONS

GENERAL

The lubrication instructions include table 1, Fluid Capacities and Lubricant Requirements, and table 2,

Lubrication Intervals and Locations. Table 2 is used for lubricating vehicles under normal operating

conditions.

SERVICE INTERVALS

Service intervals are for normal operation of the vehicle in moderate temperatures, humidity, and

atmospheric conditions. The intervals are hard-time intervals performed in accordance with the

vehicle's age, calendar, or usage such as operating time or mileage. The hard-time intervals in table 2

are based on mileage and calendar times. An example of mileage and calendar intervals is: 6/A; 6 stands

for 6,000 miles (9,656 km) and A stands for annually (every twelve months). The lubrication for the

vehicle is to be performed at whichever interval occurs firsts.

Hard-time oil service intervals must be followed for equipment under manufacturer's warranty. Hard-

time intervals may be shortened if lubricants are used under adverse conditions, including longer than

usual operating hours. Hard-time intervals may be extended during periods of low activity, although

adequate preservation precautions must be taken.

Service intervals under abnormal conditions will increase the frequency of lubricating service, such as

high or low temperatures, prolonged high-speed driving, or extended cross-country operations. These

conditions can diminish a lubricant's protective quality.

ARCTIC CONDITIONS

Refer to FM 9-207, Operation and Maintenance of Ordnance Materiel in Cold Weather 0 to -65 F

(-18 to -54 C), or table 1, Fluid Capacities and Lubricant Requirements.

CORROSION PREVENTION AND CONTROL (CPC)

Corrosion prevention and control (CPC) of Army material is a continuing concern. It is important that

corrosion problems are reported so that corrections and improvements can be made to prevent future

problems.

While corrosion is typically associated with rusting of metals, it can also include deterioration of other

materials, such as rubber and plastic. Unusual cracking, softening, swelling, or breaking of these

materials may be a corrosion problem.

If a corrosion problem is identified, it can be reported using SF 368, Product Quality Deficiency Report.

Use of key words such as corrosion, rust, deterioration, or cracking will ensure that the information is

identified as a CPC problem. This form should be submitted to the address specified in

DA Pam 738-750.

0020 00-1