 |
|||
|
|
|||
|
Page Title:
FRONT COMPOSITE LAMPS, HOUSING, AND BRACKET REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0122 00
FRONT COMPOSITE LAMPS, HOUSING, AND BRACKET REPLACEMENT (Contd)
COMPOSITE LAMPS REMOVAL
1.
Loosen five screws (2) and remove lens cover (1) and O-ring (16) from composite light housing (4).
Discard gasket (16).
2.
Remove lamp(s) (3) from composite light housing (4).
COMPOSITE LIGHT HOUSING REMOVAL
NOTE
Prior to removal, tag all lead wires for installation.
1.
Disconnect three wires (6) from wires (5).
2.
Remove two screws (7), lockwashers (8), and composite light housing (4) from upper bracket (15).
Discard lockwashers (8).
3.
Remove four locknuts (13), screws (14), lower bracket (11), and upper bracket (15) from
fender (10). Discard locknuts (13).
4.
Remove two grommets (9) and (12) from fender (10) and lower bracket (11).
COMPOSITE LIGHT HOUSING INSTALLATION
1.
Install grommets (9) and (12) on fender (10) and lower bracket (11).
2.
Install upper bracket (15) and lower bracket (11) on fender (10) with four screws (14) and new
locknuts (13).
3.
Install composite light housing (4) on upper bracket (15) with two new lockwashers (8) and
screws (7).
4.
Connect three wires (6) to three wires (5).
COMPOSITE LAMPS INSTALLATION
1.
Install lamp(s) (3) in composite light housing (4).
2.
Install new O-ring (16) and lens cover (1) on composite light housing (4) with five screws (2).
Tighten screws (2).
3.
Install intermediate turn signal, if equipped (WP 0121 00).
4.
Connect battery ground cable (WP 0126 00).
5.
Check operation of front composite light (TM 9-2320-361-10).
6.
Release parking brake and remove wheel chocks (TM 9-2320-361-10).
0122 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version