 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0024 00
ENGINE FRONT MOUNT PAD REPLACEMENT (Contd)
FRONT MOUNT PAD REMOVAL
1.
Remove two locknuts (13), washers (12), springs (11), and washers (10) from studs (2). Discard
locknuts (13).
2.
Remove two locknuts (16) and washers (15) from screws (8). Discard locknuts (16).
3.
Remove nut (20), screw (17), lockwasher (19), washer (18), and ground strap (23) from front
crossmember (6). Discard lockwasher (19).
4.
Remove two nuts (4), screws (14), clamps (5), and fuel line (7) from front crossmember (6).
5.
Push two screws (8) up through front crossmember (6), lower front pads (24), and upper front
pads (25) as far as possible.
WARNING
Do not put fingers between frame and engine support. Jack
failure may result in injury to personnel.
6.
Carefully lift engine and radiator (3), and remove two upper front pads (25) and lower front
pads (24) from front crossmember (6).
SUPPORT PLATE REMOVAL
WARNING
Do not put fingers between frame and engine support. Jack
failure may result in injury to personnel.
Place support under radiator before removing support plate.
Failure to do so may result in injury to personnel and damage
to equipment.
1.
Place support under radiator (3).
2.
Remove six screws (21), washers (22), and support plate (9) from two engine supports (1) and
studs (2).
3.
Remove two screws (8) from support plate (9).
SUPPORT PLATE INSTALLATION
WARNING
Do not put fingers between frame and engine support. Jack
failure may result in injury to personnel.
1.
Install two screws (8) on support plate (9).
2.
Install support plate (9) on two studs (2) and engine supports (1) with six washers (22) and
screws (21). Tighten screws (21) 2527 lb-ft (3437 Nm) and remove support from radiator (3).
0024 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version