 |
|||
|
|
|||
|
Page Title:
Table 2. STE/ICE-R No-Go Chain Test - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-361-24-1
0018 00
SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--
REPROGRAMMABLE STE/ICE-R NO-GO CHAIN TROUBLESHOOTING (Contd)
Table 2. STE/ICE-R No-Go Chain Test (Contd).
STARTER CIRCUIT TESTS (Contd)
NG80
TK
MODE
3
DO CURRENT PROBE OFFSET:
Connect cable W5 to batteries.
Turn off all vehicle electrical power.
Dial 90 into TEST SELECT switches.
PROMPTING
MESSAGE
Press and hold TEST until CAL message appears
on the display.
Release TEST.
Wait for offset value to appear.
Is offset value within limits of 225 and +225?
YES
NO
Proceed to TM 9-4910-571-12&P
for offset fault isolation.
4
CHECK STARTER CIRCUIT:
TEST NO.
TEST
Dial 90 into TEST SELECT switches.
89
045 VOLTS DC
Crank engine for a few seconds with fuel shutoff.
90
01500 AMPS DC
Is starter circuit above 100 amps?
NO
YES
Error Message E013 displayed in step 2 indicates
Proceed to step 5.
short circuit, frozen starter, or tight engine.
Check wiring to starter for short circuits. Repair
5
as necessary (WP 0090 00).
If wiring is OK, proceed to Engine Tightness Test
NG 130.
NG130
NOTE
After completing repair, rerun GO Chain
tests (WP 0017 00) to verify that problem
is fixed and no other problems exist.
0018 00-20
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version