|
|
TM 9-2320-361-24-1
0018 00
SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--
REPROGRAMMABLE STE/ICE-R NO-GO CHAIN TROUBLESHOOTING (Contd)
Table 2. STE/ICE-R No-Go Chain Test (Contd).
CHARGING CIRCUIT TESTS (Contd)
NG50
TK
MODE
9
CHECK FIELD CURRENT:
Install current probe around wire No. 1 of
alternator to regulator cables.
Point arrow on current probes toward alternator.
PROMPTING
MESSAGE
Dial 90 into TEST SELECT switches.
Press and hold TEST until CAL message appears.
Release TEST.
NOTE
On systems with separate rectifiers,
current probe may be placed around
wire mounts on alternator to
Start vehicle engine (TM 9-2320-361-10).
rectifier cable or rectifier cable.
Set engine speed at a fast idle speed (1200 RPM).
Turn headlights and accessories ON.
Press TEST.
Compare number on VTM display with values
given below.
Shut off engine.
Is current within range?
YES
NO
Replace alternator (WP 0085 00).
Refer to Electrical Troubleshooting Index
NOTE
from regulator to alternator using STE/ICE-R.
After completing repair, rerun GO Chain
If cables are OK, further check charging
tests (WP 0017 00) to verify that problem
system of STE/ICE-R.
is fixed and no other problems exist.
0018 00-17
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |