|
|
TM 9-2320-361-24-1
0018 00
SIMPLIFIED TEST EQUIPMENT FOR INTERNAL COMBUSTION ENGINE--
REPROGRAMMABLE STE/ICE-R NO-GO CHAIN TROUBLESHOOTING (Contd)
Table 2. STE/ICE-R No-Go Chain Test (Contd).
RED
TEST PROBE
CABLE W2
BLACK
CONNECTOR REMOVED
FROM TEMP
SENDING UNIT
OIL PRESSURE SENDING UNIT
FAULT ISOLATION
TK
GAUGE TEST (Contd)
NG31
MODE
3
ISOLATE FAULT TO SENDING UNIT OR GAUGE:
Remove wire from oil pressure sending unit on vehicle.
Connect red clip lead of W2 to wire removed from
sending unit.
Connect black clip lead to a good ground.
Press TEST.
Turn vehicle accessory switch ON.
Does VTM indicate battery voltage?
YES
NO
Refer to Troubleshooting Index
fault to wiring harness and gauge.
Replace oil pressure
sending unit (WP 0106 00).
NOTE
After completing repair, rerun GO Chain tests
no other problems exist.
0018 00-11
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |