|
|
TM 9-2320-361-24-1
0013 00
LIGHTING AND WIPER SYSTEM TROUBLESHOOTING (Contd)
Table 5. Electrical Wiper System Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test 1. Check mechanical linkage for
Replace damaged links (WP 0240 00).
WINDSHIELD WIPERS
binding or interference.
FAIL TO WORK ON
HIGH OR LOW
Test 2. Test for voltage at wiper
SETTING
switch.
1. Ensure wiper switch is
properly grounded.
2. Disconnect harness from wiper
switch.
3. Set multimeter to voltage
range that will measure
24 VDC.
4. Turn power accessory switch to
ON position.
5. Touch negative lead of
1. If voltage is present, perform test 3.
multimeter to ground and
2. If voltage is not present, go to
positive lead to lead 27 of
harness receptacle.
test 3, to check operation of power
accessory switch.
Test 3. Test for voltage at wiper motor.
1. Ensure wiper motor is
1. If properly grounded, go to step 2.
properly grounded.
2. If wiper motor is not properly
grounded, clean dirt or corrosion
from contact end and recheck
2. Disconnect harness from
wiper motor.
3. Turn wiper switch to LOW
position.
4. Touch negative lead of
1. If voltage is present, go to step 5.
multimeter to ground and
2. If voltage is not present, replace
positive lead to pin 2 of
wiper switch (WP 0240 00).
harness receptacle.
5. Turn wiper switch to HIGH
position.
6. Touch negative lead of
1. If voltage is present, replace wiper
multimeter to ground and
motor (WP 0240 00).
positive lead to pin 1 of
2. If voltage is not present, replace
harness receptacle.
wiper switch (WP 0240 00).
END OF WORK PACKAGE
0013 00-23/24 blank
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |