Table 3. Directional Signal Systems Troubleshooting Procedures - continued

TM 9-2320-361-24-1

0013 00

LIGHTING AND WIPER SYSTEM TROUBLESHOOTING (Contd)

Table 3. Directional Signal Systems Troubleshooting Procedures (Contd).

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

Test 1. Test left and right flashers.

3. BOTH DIRECTION

SIGNALS

1. Turn main light switch to

INOPERATIVE

SERVICE DRIVE position.

2. Place turn signal lever in left

position.

3. Place turn signal lever in right

If turn signals fail to flash, go to

position. Both left and right

test 2.

turn signals should flash.

Test 2. Test turn signal flasher.

1. Disconnect cable connect 467 A

and 467 B from solid state

flasher pins A and B.

2. Connect jumper wire from

cable connector 467 A and

467 B.

3. Place turn signal lever in left

position.

4. Place turn signal lever in right

1. Left and right turn signals should

position.

work but not flash. If turn signals

work, replace turn signal flasher

2. If voltage is not present, go to

WP 0013 00, malfunction 1, tests 1

through 8.

TURN

SIGNAL

FLASHER

GROUND

467A

467B

0013 00-20