|
|
TM 9-2320-361-24-1
0013 00
LIGHTING AND WIPER SYSTEM TROUBLESHOOTING (Contd)
Table 1. Lighting System Troubleshooting Procedures (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Test 2. Test dimmer switch.
1. HEADLIGHT DOES
NOT OPERATE ON
1. Ensure body ground straps
1. Remove corrosion and dirt buildup from
LOW OR HIGH
are secure and clean.
ground lead connection.
BEAM, OR BOTH
2. Tighten screws connecting ground strap
HEADLIGHTS
to frame.
INOPERATIVE
2. Check dimmer switch input 1. If voltage is present, go to step 3.
(Contd)
voltage. Remove lead 16
2. If voltage is not present, go to test 3.
from dimmer switch.
3. Check lead 16 contact end
1. Remove lead 17 from dimmer switch to
for battery voltage. Check
pin L. Remove lead 18 from dimmer
dimmer switch continuity.
switch to pin L.
2. Set multimeter to RX 1 scale. Check
continuity between input pin and pin L.
3. If continuity is not found, push dimmer
switch to change from HIGH to LOW.
Recheck continuity.
4. If no continuity is present, replace
dimmer switch (WP 0111 00).
5. If continuity is present, check continuity
between pin H and input pin.
6. If continuity is present, push dimmer
switch to ON position to change from
LOW to HIGH.
7. If continuity is not present, replace
dimmer switch (WP 0111 00).
PIN L
MAL 1
INPUT PIN
TEST 2
STEP 2
PIN H
DIMMER
SWITCH
16
17
MAL 1
18
TEST 2
STEP 2
MAL 1
TEST 2
STEP 1
0013 00-3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |