|
|
TM 9-2320-361-24-1
0013 00
LIGHTING AND WIPER SYSTEM TROUBLESHOOTING (Contd)
Table 1. Lighting System Troubleshooting Procedures (Contd).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. Turn main light switch to OFF
1. HEADLIGHT DOES
position.
NOT OPERATE ON
LOW OR HIGH
4. Disconnect leads 17 (high
BEAM, OR BOTH
beam), 18 (low beam), and 91
HEADLIGHTS
(ground) behind headlamp.
INOPERATIVE
5. Place main light switch lever
(Contd)
in SERVICE DRIVE position.
6. Check low beam and high
If voltage is present, go to step 7. If
beam voltage. Push dimmer
voltage is not present, go to
switch to LOW position. Check
test 2.
for battery voltage between
lead 18 and lead 91.
7. Push dimmer switch to HIGH
If voltage is present, go to step 8.
position. Check for battery
voltage between lead 17 and
lead 91.
8. Check continuity of low beam
If continuity is not present,
filament. Place multimeter
replace sealed beam headlamp
leads between headlamp
connectors 18 and 91 at rear of
lamp.
9. Check continuity of high beam
If continuity is not present,
filament. Place multimeter
replace sealed beam headlamp
leads between headlamp
connectors 17 and 91 at rear
of headlamp.
MAL 1
TEST 1
STEP 6
17
17
8
1
91
18
MAL 1
91
TEST 1
STEP 9
MAL 1
TEST 1
STEP 8
0013 00-2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |