 |
|||
|
|
|||
|
Page Title:
POWERPLANT HEATER TEST - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 3
NOTE
A suitable container (3) to catch overflow is needed for
this test.
1.
Hold fuel outlet (1) of fuel control valve (2) over overflow container (3).
Be sure HI-LO switch (4) is in LO position.
2.
Flip control switch (5) to RUN
position. Fuel pump should be pumping.
3.
Flip HI-LO switch (4) to HI. Let fuel flow into overflow container (3) for a
few seconds. Flip HI-LO switch (4) to LO.
Look at fuel outlet (1) for one minute. One or two drops may form, but fuel
4.
flow must be completely stopped.
Do steps 1 through 4 again. Flip control switch (5) to OFF position.
5.
If fuel flow does not stop completely when HI-LO switch (4) is flipped to LO,
6.
get a new fuel control valve.
IF FUEL CONTROL VALVE PASSES TEST, GO TO FRAME 4.
IF FUEL CONTROL VALVE FAILS TEST, GO TO FRAME 6
21-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version