 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
f.
Assembly.
FRAME 1
Put bearing (1) on shaft (2) with 3/4 inch between nut side of bearing and threaded
1.
end of shaft.
2.
Put nut (3) on shaft (2) against bearing (1).
Put in cotter pin (4).
3.
CAUTION
Make sure that end of key (5) is not touching inner race of
bearing (1).
4.
Put key (5) into keyway of shaft (2).
5.
Place gears (6 and 7) inside housing (8) as shown.
6.
Put shaft (2) into housing (8). Align key (5) in shaft (2) with keyway in
gears (6 and 7). Tap nut end of shaft (2) with soft-faced hammer until
bearing (1) goes into housing (8).
NOTE
Position shaft (2) in housing (8) so that front side of gear
(7) is seated against housing.
Tap shaft (2) to seat bearing (1) against nut (3).
7.
GO TO FRAME 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version