Inspection and Repair - continued - TM-9-2320-209-34-2-30259

TM 9-2320-209-34-2-3

FRAME 3

Check that gear (1) has no sharp fins or burrs at tooth corners. If gear is

worn or damaged, get a new one.

Check that teeth on gear (1) are not chipped or broken. If gear has chipped

or broken teeth, get a new one.

Check that gear (1) has no cracks. Use magnaflux if available. If gear is

cracked, get a new one.

Check that tooth faces of gear (1) have no nicks, scores, burrs, galling or

pitting. Repair damage using a honing stone. If more repair is needed, get

a new gear.

Measure thickness of thrust washers (2 and 3). The thickness of a new

washer is 0.120 to 0.125 inch and wear limit is 0.105 to 0.110 inch. If thick-

ness is not within given limits, get a new thrust washer.

GO TO FRAME 4

18-247