 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 17
NOTE
When putting two bushings (1) on drumshaft (2) be sure
holes in bushings are on the side away from drive gear (5).
1.
Slide inner bushing (1) on drumshaft (2).
2.
Slide inner thrust washer (3) on drumshaft (2) against bushing (1).
Put key (4) on drumshaft (2).
3.
4.
If drumshaft (2) in new, press drive gear (5) on drumshaft 2 3/8 inches,
between end of drumshaft and outer hub of drive gear.
Drill two 5/16-inch diameter holes in drumshaft (2). Use holes in drive gear
5.
(5) as a guide. Be sure holes are as deep as those in old shaft.
Put setscrews (6) in drive gear (5).
Tighten against drumshaft (2).
6.
7.
Tie setscrews (6) and drive gear (5) together with safety wire (7).
8.
Slide outer thrust washer (3) on drumshaft (2).
Put outer bushing (1) against gear (5).
9.
GO TO FRAME 18
18-129
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version