 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 8
Turn sprocket (2) until stop lug on brake collar (1) is on top.
1.
NOTE
During the following procedure, the location of the
stop lug on brake collar (1) must be known at all
times.
2.
Press hard on sprocket (2), forcing worm (3) to move as far forward as
possible.
With stop lug on brake collar (1) on top, thread worm brake (4) onto stud
3.
end of worm (3) until the outer face of brake is 3 1/32 inches from the inner
face of bearing housing (5).
Put tapered end of stop pin (6) into the nearest hole to the left of stop lug
4.
on brake collar (1). Tap pin until end of pin is slightly below surface of
worm brake (4).
Put new gasket (7) and retaining plate (8) on worm brake (4).
5.
Put two capscrews (9) and washers (10) on retaining plate (8).
6.
GO TO FRAME 9
18-120
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version