 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-209-34-2-3
FRAME 6
1.
Put new gasket (1) and bearing retainer (2) on bearing housing (3).
2.
Put two capscrews (4) on the lower part of bearing housing (3) and bearing
retainer (2).
NOTE
The upper capscrews are put in during installation of
cable level winder assembly.
Tie capscrews (4) together with safety wire (5).
3.
Put spacer (6) on wormshaft (7) up against outer bearing assembly (8).
4.
5. Be sure that oil seal (9) is properly seated around spacer (6).
GO TO FRAME 7
18-118
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version