Chapter 18. WINCH, HOIST, AND POWER TAKEOFF ASSEMBLIES GROUP MAINTENANCE

TM 9-2320-209-34-2-3

WINCH, HOIST, AND POWER

TAKEOFF ASSEMBLIES GROUP MAINTENANCE

Section I. SCOPE

18-1. EQUIPMENT ITEMS COVERED. This chapter gives equipment maintenance

procedures for the winch and hoist assemblies, and power takeoff assembly for which

there are authorized corrective maintenance tasks at the direct and general support

maintenance levels.

18-2. EQUIPMENT ITEMS NOT COVERED. All equipment items for which corrective

maintenance is authorized at the direct and general support maintenance levels are

covered in this chapter.

Section II. WINCH AND HOIST ASSEMBLIES

18-3. FRONT WINCH REPAIR.

TOOLS:

No special tools required

Solvent, dry cleaning, type II (SD-2), Fed. Spec P-D-680

SUPPLIES:

Clean rags

Gearcase cover gasket

Bearing cap gasket

Sliding clutch key (2)

Brake case gasket

Preformed packing

Brake case cover gasket

PERSONNEL:

TW O

EQUIPMENT

CONDITION: Truck parked, engine off, handbrake set.

Preliminary Procedures.

Refer to TM 9-2320-209-20.

(1) Remove front winch.

(2) Drain front winch.

Refer to LO 9-2320-209-12/1.