 |
|||
|
|
|||
|
Page Title:
END GATE CONTROL LINKAGE REMOVAL, REPAIR, AND REPLACEMENT (TRUCK M342A2) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-209-34-2-2
Tailgate Linkage Adjustment.
h.
FRAME 1
1.
Put hand lever (1) in locked position. Check that two locking latches (2) close fully
over two tailgate pivot pins (3). If locking latches are fully closed, END OF TASK.
2.
If locking latches (2) did not fully close, loosen two nuts (4), one on each side of
dump body, two turns. Hold nuts and tighten two nuts (5).
3. Do step 1 again. If needed, do steps 1 and 2 again until locking latches (2) fully
close.
END OF TASK
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version